|
Australian Hobby Casting
Kit No. F035
NDPF Covered Ballast Plough
Polyurethane and Laser-cut Styrene Kit
Image shows assembled body without detail such as brake and plough wheels, decals, couplers, piping over the body etc. All will be supplied with complete kit.
$TBA
|
|
|
Kit No. N001
NHBF Bogie Ballast Wagon
Those of you who've been in the hobby for a while might remember the Hanovale NHBF.
It wasn't around all that long because, well to be blunt, it just didn't go together at all well. But now it's been remastered
and will shortly be available again. This time it's got a one piece hopper that goes on the solid underframe that
includes the discharge chutes. The side bracing is made of laser-cut styrene, as are the discharge linkages.
Now we've just got to make a few minor changes.
|
|
|
Kit No. F034
RCWF Bogie Wire Coil Wagon
Our NCWF was only suitable for those modeling the brief period between the introduction of the NCWF in 1985
and 1988 when they were all converted to the double layer version. To make matters worse the single layer version was
only seen between Sydney and Newcastle whereas the extended version can be seen over most of the interstate standard
gauge routes. The model will consist of the original version kit plus laser-cut styrene to represent the extended
superstructure. The kit also includes a jig so that modelers can get the placement of the superstructure elements right
without too much difficulty. The original version will be discontinued as a separate model but can still be made from
the kit. The kit will have decals for both the NCWF and RCWF codes. Release will follow the NHBF.
|
|
|
Kit No. LO03
Low Relief
Art Deco Shop Front
Under Development
Laser-cut Styrene Kit
$TBA
Photo shows development version, production version is lower overall and has slightly lower awning.
[Return to Top]
|
|
|
Kit No. LO05
Late Victorian / Federation Shop Front
Under Development
Laser-cut Styrene Kit
$TBA
[Return to Top]
|
(sorry, no photograph yet)
|
|
Kit No. LO07
Late Victorian / Federation Shop Front
Under Development
Laser-cut Styrene Kit
$TBA
Includes decals
Photo shows development version. Production version has higher awning and taller building.
[Return to Top]
|
|
|
Kit No. LO13
Late Victorian / Federation Shop Front
Under Development
Laser-cut Styrene Kit
$TBA
[Return to Top]
|
(sorry, no photograph yet)
|
|
Kit No. LO15
Late Victorian / Federation Shop Front
(with parapet)
Under Development
Laser-cut Styrene Kit
$TBA
[Return to Top]
|
(sorry, no photograph yet)
|
|
Kit No. LO17
Cinema
Under Development
Laser-cut Styrene Kit
$TBA
Photo shows development version; production version has slightly raised awning and features board.
[Return to Top]
|
|
|
Kit No. NW32
RUB Car Interior
Under Development
$TBA
[Return to Top]
|
(sorry, no photograph yet)
|
|
Kit No.
NQTY/NQYY Bogie Container Wagon
Brass and laser-cut styrene
The NQTY/NQYY are short container wagons derived from the NODY open wagon. The NQTY differs from the
NQYY only in the type of container lock installed. These wagons are used for a number of purposes including
Goonumbla and Blayney mineral concentrate traffic, interstate containerised steel traffic, interstate
intermodal traffic and metropolitan trip workings.
The kit will be made of laser cut styrene with an etched brass deck. There are still substantial modifications
to be made to the pattern and this kit is still some time off.
|
|
